Submenus

Enter a function's submenu by clicking the MIDDLE button. Exit a function's submenu by doing a long press on the UP button.

Edit_Mode__Submenu.png

Movement Range (Tilt, Pan & Roll)

Adjust the movement range of a function by clicking the MIDDLE button and then trace the desired range of it out in the air. Click the MIDDLE button again when finished.

The default range of each movement is from 0 to 90 degrees. The range of a movement controls its sensitivity. If the range is small the movement becomes more sensitive, and if the range is large the movement will be less so.

The position where you start tracing will become the movements starting point when you Reset the movements (long press on MIDDLE button).

You can for example start in the middle, trace upwards and then move past your starting point when you trace downwards. This way the starting point will be in the middle of the movement.
WM_6-02.png

 

Movement Sensitivity (Vibrato)

You can change the sensitivity of the Vibrato by clicking the MIDDLE button and then adjust the sensitivity by using the UP and DOWN buttons.

The sensitivity block has 5 stages represented by lines. The more lines the block has the more sensitive the Vibrato is. Click the MIDDLE button again when finished.

WM_7-02.png

 

 
Movement Direction (Tilt, Pan, Roll & Vibrato)

You can invert the movement direction by clicking the MIDDLE button on Wave. When you do the arrow should flip.

This will make the parameter you are controlling move in the opposite direction of your movement.

WM_8-02.png

 

 
CC Value

You can adjust the CC value for each function. There are two ways possible to do this.

Either click the MIDDLE button and use the UP and DOWN buttons to change the number manually. Click the MIDDLE button again when finished.

Or click the MIDDLE button to activate MIDI Learn. Simply turn a knob on your hardware device and its CC number should register automatically.

*Pro Tip - You can shortcut your way to MIDI Learn in the main menu by holding the MIDDLE button.

WM_11-02.png

 

 
Output Range (Tilt, Pan, Roll & Vibrato)

You can adjust each function's Output range. The default is 0-127 but you can change this number manually using the UP and DOWN buttons.

There are two screens for this feature, one for the min Output and another one for the max Output.

Click the MIDDLE button and change the number. Click again when finished.

You can also use a parameter on your synth to adjust the number.

WM_12-02.png

 

 
Trigger Sensitivity (Tap)

You can change the sensitivity of the Tap by clicking the MIDDLE button and then adjust the sensitivity by using the UP and DOWN buttons.

The sensitivity block has 5 stages represented by lines. The more lines the block has the more sensitive the Tap is. Click the MIDDLE button again when finished.

WM_13-02.png

 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.